MichaelBC
Standlicht oder Umschaltung von Tagfahrlicht zu Abblendlicht ?
Schaltplan / Stromlaufplan
Diskutiere Schaltplan / Stromlaufplan im R 1250 GS und R 1250 GS Adventure Forum im Bereich Motorrad Modelle; Standlicht oder Umschaltung von Tagfahrlicht zu Abblendlicht ?
rinalds2m
Ok, Aber wenn ich diesere pin nach hintere Multifuncion Blinkern bringe und kodiere ordentlisch die BCO, dass Scheinwerfer wird arbeiten ohne Probleme?
MichaelBC
Warum willst du das Kabel vom Scheinwerfer an den Blinkern anschließen ?
rinalds2m
Ich habe es schon gemacht - ein Multifunkcion Blinker Retrofit fuer mein GS BJ2019. Nur ich habe jetzt gedenkt od dass Scheinwerfer wird arbeiten. Ich habe keine Fehler gemerkt und auch ISTA zeigt keine Fehler...
b4n24i
- Dabei seit
- 30.11.2023
- Beiträge
- 53
- Modell
- GS1250 TE
I can guess, being the thinner wire of three, and the other two being thicker, that pin 29 is position lights and the other two are low and high beam...
rinalds2m
Also ich shreibe auf english besser, weil es gehts fuer mich besser. 
The wire (grey/blue 0,35mm2) from Pin 29 BCO to Pin 3 in front light really is just a spare wire. It has no function what so ever! I guess it is designed for some future updates and retrofits.
I went to garage, double checked my front light for right function and it works perfectly:
After that I removed the plug from front light and looked it over - There is no corresponding pin in the front headlight for the pin 3 in the plug!
So the question about what 58P2_12V does is solved. Nothing.
Few pictures in attachment for better understanding:
Conclusion... The retrofit and coding is safe and can be used without worries!
Coding for rear light retrofit:
gen_LightModules_Freq: 100_Hz [00 64] -> gen_LightModules_Freq: 200_Hz [00 C8]
led_fibl_active: not_active [00] -> led_fibl_active: active [01]
pol_UseFrontPosLightForBrakeLight2_Enable: Not_Active [00] -> pol_UseFrontPosLightForBrakeLight2_Enable: Active [01]
The wire (grey/blue 0,35mm2) from Pin 29 BCO to Pin 3 in front light really is just a spare wire. It has no function what so ever! I guess it is designed for some future updates and retrofits.
I went to garage, double checked my front light for right function and it works perfectly:
After that I removed the plug from front light and looked it over - There is no corresponding pin in the front headlight for the pin 3 in the plug!
So the question about what 58P2_12V does is solved. Nothing.
Few pictures in attachment for better understanding:
Conclusion... The retrofit and coding is safe and can be used without worries!
Coding for rear light retrofit:
gen_LightModules_Freq: 100_Hz [00 64] -> gen_LightModules_Freq: 200_Hz [00 C8]
led_fibl_active: not_active [00] -> led_fibl_active: active [01]
pol_UseFrontPosLightForBrakeLight2_Enable: Not_Active [00] -> pol_UseFrontPosLightForBrakeLight2_Enable: Active [01]
Thema:
